User Guide

Poly Studio E70 Release Notes 1.7.0
5
Resolved Issues
This section identifies the resolved issues in this release.
Category
Issue ID
Description
Camera EN-235989 Switching to an additional Studio E70 in Zoom mode causes the camera to fail on
a Studio X70 system.
Camera EN-233466
On a G7500 system with a Studio E70 camera powered using a G7500 LLN port,
the Studio E70 camera doesn’t show up in the system web interface, and the
LED flashes blue after you upgrade the G7500 system.
Camera EN-233412
Upgrading a Studio E70 camera results in the camera becoming stuck in DFU
mode.
Camera EN-221948
When using Studio X70 and Studio E70 with a G7500 system, the camera
presets turn off and on.
Known Issues
This section identifies the known issues in this release.
IMPORTANT:
These release notes do not provide a complete listing of all known issues for the software.
Issues not expected to significantly impact customers with standard voice and video
conferencing environments may not be included. In addition, the information in these release
notes is provided as-is at the time of release and is subject to change without notice.
Category
Issue ID
Description
Workaround
Camera EN-238553 On a Studio X70 system with a connected
Studio E70 camera, video does not swap
between tele and wide lens in pan-tilt-
zoom (PTZ) mode.
None.
Camera EN-237005
After updating to 4.0.0, on a G7500
system with a connected Studio E70,
video latency shows after the system is
left idle.
Restart the system.
Camera EN-234479
On a G7500 system with three USB-
connected Studio E70 cameras powered
by G7500 LLN ports, one or more Studio
E70 cameras may not properly connect to
the video conferencing system after
restart.
Restart the system.
Camera EN-233998
On a Studio G7500 or Studio X Family
system in Device Mode with a connected
Studio E70 camera, you can’t toggle
camera tracking on after saving a preset
on the TC8.
Change tracking settings in outside of
Device Mode or use the system web
interface.