Users Manual

Screen shot
Step 3: Give the repeater a name and press “save”
Step 4: Power on the repeater(s) and registration will start.
When the LED is steady green the repeater is successfully registered.
Screen shot
PARAMETERS DESCRIPTION
IDX System counter
RPN SINGLE CELL SYSTEM:
The base has always RPN00, first repeater will then be RPN01, second repeater RPN02
and third RPN03 (3 repeaters maximum per base)
MULTI CELL SYSTEM:
Bases are increment by 2^2 in hex, means first base RPN00 second base RPN04 etc., in
between RPN01, 02, 03 addressed for repeaters at Primary base and 05, 06, 07 addressed
for Secondary base (3 repeaters maximum per base)
NAME/IPIE Name and IPIE number of the repeater
DECT SYNC MODE DECT Sync mode – Manually or Automatic
STATE State of the repeater Enabled/Disabled
FW INFO Firmware version
FWU PROGRESS How many percentages of the firmware is loaded / Off if no firmware is being loaded