Users Manual

SME VOIP SYSTEM GUIDE 1.1 87 | P a g e
Proprietary and Confidential
6 How-To setup a Multi Cell System
This chapter describes how to setup a multi cell system, add and synchronize one or multiple Base stations to the
network.
NOTE: It is possible to have RTX8660 and Rove B4 in the same chain, but the features of the system will be reduced to
RTX8660. This means that if a user has a multi cell system with 50x Rove B4 and adds 1x RTX8660, the system will run
on the RTX8660 features and exclude the extra ones from Rove B4.
6.1 Adding Base stations
Here are the recommended steps to add Base stations to network:
STEP 1 Connect the Base station to a private network via standard Ethernet cable (CAT 5).
STEP 2 Use one of the two methods to determine the Base station IP address.
a. Use the IP find menu on the handset (enter the main Menu and type *47*) to determine the IP
address of the Base station by matching the MAC address on the back of the device with the MAC
address list on the handset
b. Use the IPdect feature (for more details, go to chapter 3.5.2 Using Browser IPDECT )
STEP 3 Open browser on the computer and type in the IP address of the base. Press “Enter” to access the
base Login to the Base station.
STEP 4 Once you have been authenticated, the browser will display front end of the SME Configuration
Interface. The front end will show relevant information of the Base station.
Screenshot