Users Manual

SME VOIP SYSTEM GUIDE 1.1 76 | P a g e
Proprietary and Confidential
PARAMETERS
DESCRIPTION
IDX/NAME Base IP address and Base station name from management settings
OPERATION
D-H:M:S
Total operation time for the repeater since last reboot or reset
Duration is the time from data was cleared or system has been firmware upgraded.
BUSY Busy Count is the number of times the repeater has been busy.
BUSY DURATION
D
-
H:M:S
Busy duration is the total time a repeater has been busy for speech (5 or more calls
active).
MAX ACTIVE Maximum active calls are the maximum number of calls that has been active at the same
time.
SEARCHING Repeater searching is the number of times a repeater has been searching for it’s sync
source
RECOVERY In case the sync source is not present anymore the repeater will go into lock on another
base or repeater and show recovery mode
DECT SOURCE
CHANGED
Number of time a repeater has changed sync source
WIDE BAND Number of wideband calls on repeaters
NARROW BAND Number of narrow band calls on repeaters
DECT data
Data is organized in a table as shown in the below example.
Screenshot
PARAMETERS
DESCRIPTION
FREQUENCY Number of the DECT slot frequency
SLOTX
Number of connections that have been active on each frequency