User Guide

Connect your Poly/Plantronics supported USB corded headset or wireless USB headset

adapter to the MDA220 USB headset port.*

NOTE Your headset will continue to function as if it were connected directly to the computer.

*For a list of supported headsets and wireless USB headset adapters see poly.com/support

There are three options for connecting the MDA220 to your desk phone.

• Desk Phone (standard)

• Desk phone + HL10 lifter and power supply (sold separately)

• Desk phone + EHS cable (sold separately)

NOTE If you will be using Desk phone (standard) or Desk phone +HL10 lifter and power supply

continue below. If you will be using the Desk Phone + EHS cable, refer to EHS Getting Started

guide that came with your EHS cable or at poly.com/accessories for installation instructions.

Desk Phone (standard)

1 Connect one end of the telephone interface cable to the back of the switcher.

2 Disconnect the handset coil cord from the base of the desk phone and re-connect it to the

telephone interface cable junction box.

3 Connect the remaining end of the telephone interface cable into the open handset port on

the desk phone.

Your desk phone handset will continue to work; it’s just hooked up differently.

USE

NOTE If your phone has a built-in headset port, you should only use the headset port if you will

not be using the HL10 lifter. In this configuration, you must press both the headset button on

your phone and the call button on the headset to answer or end calls

Setup

Connect your Headset

Desk Phone: Connect

and Call