User Manual

USE
• Connect one end of the telephone interface cable to the back of the base
• Disconnect the handset coil cord from the base of the desk phone and re-connect it to the
telephone interface cable junction box
• Finally connect the remaining end of the telephone interface cable into the open handset port
on the desk phone
• Adjust the configuration switch on the bottom of the base to default
A, which works for most
phones. Use configuration
D for Cisco phones.
NOTE Use this setup if you are not using the HL10 lifter or EHS cable and your desk phone does
not have a dedicated headset port. In this configuration, manually remove the handset on your
desk phone and press the call control button on the headset to answer or end calls.
C Desk phone + EHS cable (sold separately)
USE
• Adjust the configuration switch on the bottom of the base to default A, which works for most
phones.
D Desk phone + HL10 lifter (sold separately)
6