Installation Guide

EZ2011 - END PKG, DOOR, EZ
DETAIL A
BILL OF MATERIALS
DESCRIPTIONITEM CODEQTY
ID
BENCH FRAME, DOOR END, LHEZ100311
BENCH FRAME, DOOR END, RH
EZ100512
THRESHOLD, DOOR
EZ110713
HEADER, DOOREZ11101
4
PEAK, ENDEZ11241
5
PEAK SUPPORT, END, LH
EZ112616
PEAK SUPPORT, END, RHEZ11281
7
JAMB, DOOR, LATCH SIDE
EZ113118
DOOR, PREHUNG, 42.75 x 80, LHREZ113819
END CAP, GM2000GMSA51210
CARRIAGE BOLT, 5/16"x2-1/2", G5
NB1816211
WASHER, LOCK, 5/16" ZPNB1862212
WING NUT, 3/8" ZP
NB1901713
WING NUT, 5/16" ZP
NB1903214
WASHER, FLAT, NYLONNB1923
7
15
A
DOOR FRAME ASSEMBLY EZ2011
8
REV: AE-201007
PEAK
SUBASSEMBLY
1. Assemble Frames on a flat surface in the
following order:
2. Assemble the RH Peak Support (EZ1128),
End Peak (EZ1124) and LH Peak Support
(EZ1126) as shown.
3. Parts may need to be shaken or wiggled
to insert the swaged end of a component
into the receiving part. A moderate tap of
the rubber mallet may also be required to
completely set all insertions.
4. Position the PEAK SUBASSEMBLY, so that the
WIGGLE WIRE BASE is facing up.
5. Attach the Door Header (EZ1110) to the PEAK
SUBASSEMBLY using (2) 5/16" Carriage Bolts (NB1816),
(2) 5/16" Lock Washers (NB1862), and (2) 5/16" Wing Nuts
(NB1903).
3
14
12
11
11
14
12
15
13
4
5
7
10
13
15
13
15
2
1
9
8
10
15
13
15
13
15
13
13
15
6
6
5
7
PEAK / HEADER
SUBASSEMBLY
4
PEAK
SUBASSEMBLY
11
12
14
11
12
14
WIGGLE WIRE BASE
(PREASSEMBLED)