Installation Guide

EZ2014 - FRAME CONNECTOR PKG, EZ
DETAIL Y
BILL OF MATERIALS
DESCRIPTIONITEM CODEQTY
ID
X-BRACEEZ1100
4
1
PURLIN, BASKET, 73 1/2"GM4000
32
SLIDE BAR, GM 2000GMSA52
23
ASSY, S.A. BOTTOM RAIL, 74"SA40132
4
ASSY, S.A. TOP RAIL, 74" (BROWN)SA4018
2
5
3'-0" x 55 1/4" 8MM CLR PCSSSS1005
46
CARRIAGE BOLT, 1/4"x 3/4", G5NB1820
47
WASHER, LOCK, 1/4" ZP
NB186048
WING NUT, 1/4" ZPNB190249
SNAPPER PIN, .250" x 2.25"NB1996210
SLIDE SIDE INSTALLATION
18
REV: AE-201007
Y
2
6
3
1
1
8
10
7
2
2
6
6
4
5
1
1
7
8
4
5
6
7
8
9
7
8
9
9
9
3
4. Remove the protective film from the Clear Polycarbonate Panels (SS1005) and be certain to install the Panels with the
UV protective (blue) side to the outside of the structure.
5. Set the Panels into the Bottom Rail and bend the middle outward until the panel is short enough to insert into the Top Rail.
6. Slide the Panels toward the center of the opening and attach the Slide Bars (GMSA52) to the End Caps (GMSA51) and
Dividers (GMSA50) using a 1/4" Carriage Bolt (NB1820), 1/4" Lock Washer (NB1860) , and 1/4" Wing Nut (NB1902) at each
Slide Bar end as shown.
7. Secure the structure to the ground surface as shown in the ANCHORING LAYOUT instructions.
1/4" Carriage Bolt
(NB1820)
1/4" Lock Washer
(NB1860)
1/4" Wing Nut
(NB1902)