NT4500 nesting table set ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. NT4500 v1.0.
NT4001 21" x 56" TABLE TOP NT4000 22.5" x 64" TABLE TOP NT4002 24" x 72" TABLE TOP NB1974 3/16" HEX WRENCH NT4005 34" LEG (4) NB1862 5/16" LOCK WASHER (48) NT4004 30" LEG (4) NB1970 5/16" CAP SCREW (48) NT4003 26" LEG (4) NB1886 5/16" FLAT WASHER (48) NB1872 5/16" HEX NUT (48) 3/16" hex wrench (included) & 1/2" open-end wrench are required to assemble this product.
LOCK WASHER HEX NUT CAP SCREW FLAT WASHER 1. PLACE LEGS INSIDE TABLE TOP AS SHOWN. 2. FASTEN TO TABLE TOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. 3. STRAIGHTEN LEGS AND TIGHTEN SCREWS SECURELY. 4. REPEAT STEPS 1-3 ON REMAINING TABLES. THE 24" x 72" TABLE TOP USES 34" LEGS. THE 22.5" x 64" TABLE TOP USES 30" LEGS. THE 21" x 56" TABLE TOP USES 26" LEGS.
Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. Lock casters (when provided) once display is in place to prevent movement. Remove all debris or obstacles from caster's path before moving.
