NT3010 nesting table set ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. NT3010 v1.0.
NT1007 24" x 22" TABLE TOP (1) NT1006 24" x 30" TABLE TOP (1) NT1008 22" x 14" TABLE TOP (1) NT1003 30" LEG (4) NB1970 CAP SCREW (24) NT1004 25 3/4" LEG (4) NB1886 FLAT WASHER (24) NB1862 LOCK WASHER (24) NT1005 21 1/2" LEG (4) NB1974 3/16" HEX WRENCH (1) NB1872 HEX NUT (24) 3/16" hex wrench (included) & 1/2" open-end wrench are required to assemble this product.
CAP SCREW HEX NUT LOCK WASHER FLAT WASHER 1. PLACE LEGS INSIDE TABLE TOPS AS SHOWN. 2. FASTEN TO TABLE TOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. 3. REPEAT FOR ALL FOUR LEGS ON ALL THREE TABLES. THE 24" x 30" TABLE TOP USES (4) 30" LEGS. THE 24" x 22" TABLE TOP USES (4) 25 3/4" LEGS. THE 22" x 14" TABLE TOP USES (4) 21 1/2" LEGS.
Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. Lock casters (when provided) once display is in place to prevent movement. Remove all debris or obstacles from caster's path before moving.
