ASSEMBLY IN STRUCTIO NS IMPO R T A N T Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. FB3032 v1.0.
FB2033 BENCH END (2) FB2533 STABILIZER (1) FK1004 12" x 6' BENCH TOP (7) FT3602 3/4" BENCH CLIP (14) NB1924 THUMB SCREW (14) NB1901 3/8" WING NUT (4) No tools are required to assemble this product.
BENCH END STABILIZER 1. ATTACH STABILIZER TO BENCH ENDS USING NYLON WASHERS AND WING NUTS. BENCH END BENCH TOP 2. SET BENCH TOPS ON BENCH ENDS. SECURE USING BENCH CLIPS AND THUMB SCREWS AS SHOWN IN FIGURE 1 BELOW.
BENCH TOP (ONLY ONE SHOWN) BENCH END WITH CASTERS 3/4" BENCH CLIP WITH THUMB SCREW STABILIZER INSTRUCTIONS: 1. ASSEMBLE DISPLAY AS YOU WOULD A STANDARD BENCH (SEE PAGE 3), BUT ASSEMBLE USING BENCH ENDS WITH CASTERS (FB2034). FB2035 BENCH END W/CASTERS (2) ONCE DISPLAY IS IN PLACE, ALL CASTERS MUST BE LOCKED TO PREVENT MOVEMENT. THE BRAKE IS ACTIVATED BY ROTATING THE LEVER FROM THE "OFF" POSITION TO THE "ON" POSITION.
EXISTING BENCH TOP (ONLY ONE SHOWN FOR CLARITY) ADJOINING BENCH TOP (ONLY ONE SHOWN FOR CLARITY) 3/4" BENCH CLIP W/THUMB SCREW ADJOINING BENCH END EXISTING STABILIZER EXISTING BENCH END ADJOINING STABILIZER INSTRUCTIONS: 1. ATTACH ADJOINING UNIT'S STABILIZER AND BENCH END TO THE EXISTING UNIT'S BENCH END. 2. SET BENCH TOPS DOWN OVERLAPPING EXISTING BENCH TOPS AS SHOWN BELOW. 3.
Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. Lock casters (when provided) once display is in place to prevent movement. Remove all debris or obstacles from caster's path before moving.
