ASSEMBLY IN STRUCTIO NS IMPO R T A N T Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. FB3025-4 v1.0.
FB2023 BENCH END (2) FT3600 NORSTAD CLIP (4) FT3200 STACKER CLIP (4) FB2539 STABILIZER (1) NB1924 THUMB SCREW (8) RF2548 23" x 4' BENCH TOP (2) NB1901 WING NUT (4) RF2543 18" x 4' BENCH TOP (1) RF2547 12" X 4' BENCH TOP (1) NB1923 NYLON WASHER (4) No tools are required for the assembly of this product.
FLAT MATE - 4' STABILIZER 1. ATTACH STABILIZER TO THREADED STUDS ON BENCH ENDS USING NYLON WASHERS AND WING NUTS. 2. SET BENCH TOPS IN PLACE. 3. SECURE UPPER BENCH TOPS WITH STACKER CLIPS. SEE FIGURE 1 4. SECURE LOWER BENCH TOPS WITH NORSTAD CLIPS.
FLAT MATE - 4' EXISTING UNIT ADJOINING UNIT STABILIZER ADJOINING UNIT BENCH END EXISTING UNIT BENCH END INSTRUCTIONS: SECURE CLIPS ONLY ON END UNITS OF MULTIPLE UNITS JOINED TOGETHER. 1. ATTACH ADJOINING UNIT'S STABILIZER AND BENCH END TO THE EXISTING UNIT'S BENCH END. SET BENCH TOPS OVERLAPPING EXISTING BENCH TOPS AS SHOWN IN FIGURE 1.
BENCH END WITH CASTER (FB2026) INSTRUCTIONS: 1. SLIDE CASTER RAIL INTO BOTTOM OF BENCH ENDS. 2. TIGHTEN THUMB SCREWS TO LOCK INTO PLACE. BENCH END LEG CASTER RAIL (FB2044) THUMB SCREW CASTER RAIL ONCE DISPLAY IS IN PLACE, ALL CASTERS MUST BE LOCKED TO PREVENT MOVEMENT. THE BRAKE IS ACTIVATED BY ROTATING THE LEVER FROM THE "OFF" POSITION TO THE "ON" POSITION.
Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. Lock casters (when provided) once display is in place to prevent movement. Remove all debris or obstacles from caster's path before moving.
