FB3009 angled bench display ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. FB3009 v1.0.
PARTS IDENTIFICATION BENCH END (FB3070) qty (2) STABILIZER (FB2537) qty (1) 23" BENCH TOP (RF2555) qty (1) 3' BENCH TOP (RF2552) qty (1) FRONT RAIL (FB3071) qty (1) 2 NORSTAD CLIP (FT3600) qty (2) THUMB SCREW (NB1924) qty (4) NYLON WASHER (NB1923) qty (4) WING NUT (NB1901) qty (4)
ASSEMBLY INSTRUCTIONS BENCH END THUMB SCREW STABILIZER FRONT RAIL NYLON WASHER WING NUT LIP POINTS DOWNWARD INSTRUCTIONS: 1. ATTACH STABILIZER TO BENCH ENDS USING NYLON WASHERS AND WING NUTS. 2. ATTACH FRONT RAIL TO BENCH ENDS USING THUMB SCREWS. LIP OF FRONT RAIL SHOULD POINT DOWNWARD (SEE FIGURE 1 ).
ASSEMBLY INSTRUCTIONS 3' BENCH TOP 23" BENCH TOP BENCH TOP SHOULD REST UNDERNEATH LIP OF FRONT RAIL NORSTAD CLIP WITH THUMB SCREW INSTRUCTIONS: 1. PLACE 23" BENCH TOP ON LOWER LEVEL OF BENCH ENDS. FASTEN TO BENCH ENDS USING NORSTAD CLIPS AND THUMB SCREWS. SEE FIGURE 1 BELOW. 2. PLACE 3' BENCH TOP ON UPPER LEVEL OF BENCH ENDS. BENCH TOP SHOULD REST UNDER EDGE OF FRONT RAIL, HOLDING BENCH TOP IN PLACE. SEE DETAIL ABOVE.
OPTIONAL CASTERS BENCH END WITH CASTERS ONCE DISPLAY IS IN PLACE, ALL CASTERS MUST BE LOCKED TO PREVENT MOVEMENT. THE BRAKE IS ACTIVATED BY STEPPING DOWN ON THE LEVER. INSTRUCTIONS: 1. INSTALL PER STANDARD ASSEMBLY INSTRUCTIONS (PAGES 3 & 4) USING BENCH ENDS WITH CASTERS (FB3073) INSTEAD OF BENCH ENDS WITHOUT CASTERS (FB3070).
OPTIONAL SIGN HOLDER WING NUT FLAT WASHER CARRIAGE BOLT REMOVE BLACK PLASTIC CAP INSTRUCTIONS: 1. REMOVE BLACK PLASTIC CAP FROM TOP OF BACK LEG ON EACH BENCH END. 2. INSERT POSTS INTO TOP OF BACK LEG ON EACH BENCH END MAKING SURE THE HOLE FOR MOUNTING THE SIGN HOLDER IS TOWARDS THE FRONT AND BACK OF THE DISPLAY. 3. FASTEN SIGN HOLDER TO POSTS USING CARRIAGE BOLTS, FLAT WASHERS, AND WING NUTS AS SHOWN.
ASSEMBLY INSTRUCTIONS - CONNECTED RUNS ADJOINING BENCH END THUMB SCREW ADJOINING STABILIZER END UNIT STABILIZER ADJOINING FRONT RAIL END UNIT BENCH END END UNIT FRONT RAIL END UNIT BENCH END * BENCH TOP (EXISTING) * INSTRUCTIONS: BENCH TOP (ADJOINING) BENCH END BENCH TOP SUPPORT TUBE 1. ATTACH ADJOINING UNIT'S STABILIZER AND BENCH END TO THE END UNIT'S BENCH END. 2. SET BENCH TOPS DOWN OVERLAPPING END UNIT'S BENCH TOPS AS SHOWN ABOVE. 3.
SAFETY GUIDELINES Do not climb, sit on, or use this product as a ladder due to possible injuries. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock is possible. Do not place this product on a slope that exceeds 10 degrees. If your display does not have casters, do not move this display after product is in place. Damage to display and injuries may occur. If your display does have casters, once in place, all casters must be locked to prevent movement.
