FB3006 bench display ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. FB3006 v1.0.
BENCH END (FB2012) qty (2) STABILIZER (FB2537) qty (1) BENCH TOP (RF2552) qty (2) NORSTAD CLIP (FT3600) qty (4) THUMB SCREW (NB1924) qty (4) 3/8" WING NUT (NB1901) qty (4) 3/8" NYLON WASHER (NB1923) qty (4)
BENCH END STABILIZER 3/8" WING NUT 3/8" NYLON WASHER INSTRUCTIONS: BENCH END 1. ATTACH STABILIZER TO BENCH ENDS USING NYLON WASHERS & WING NUTS. 2. PLACE BENCH TOPS ON BENCH ENDS. 3. INSTALL NORSTAD CLIPS PER FIGURE 1 BELOW.
U-BRACE (FB2002) qty (2) 49" BASKET POST (FB2003) qty (4) BASKET PURLIN (GM4000) qty (4)
BASKET PURLIN U-BRACE 49" BASKET POST ASSEMBLED FB3006 BENCH DISPLAY INSTRUCTIONS: 1. PLACE 49" BASKET POSTS INTO BENCH ENDS. 2. PLACE U-BRACES ONTO BASKET POSTS. 3. ATTACH BASKET PURLINS USING 5/16" x 2" LONG CARRIAGE BOLTS, LOCK WASHERS, AND WING NUTS.
CASTER RAIL ASSEMBLY (FB2004) 5/16" THUMB SCREW (4) PLACES OPEN SIDE FACES OUT INSTRUCTIONS: THUMB SCREW TO INSTALL OPTIONAL CASTER RAILS, SLIDE CASTER RAILS INTO BENCH ENDS. TIGHTEN THUMB SCREWS SECURELY TO LOCK INTO PLACE. END FRAME CASTER RAIL ONCE DISPLAY IS IN PLACE, ALL CASTERS MUST BE LOCKED TO PREVENT MOVEMENT. THE BRAKE IS ACTIVATED BY ROTATING THE LEVER FROM THE "OFF" POSITION TO THE "ON" POSITION.
END UNIT BENCH TOP ADJOINING BENCH TOP END UNIT STABILIZER END UNIT BENCH END ADJOINING STABILIZER NORSTAD CLIP W/THUMB SCREW ADJOINING BENCH END INSTRUCTIONS: 1. ATTACH ADJOINING UNIT'S STABILIZER AND BENCH END TO THE END UNIT'S BENCH END. 2. SET BENCH TOPS DOWN OVERLAPPING END UNIT'S BENCH TOPS AS SHOWN BELOW. 3. SECURE NORSTAD CLIPS ONLY ON END UNITS OF MULTIPLE UNITS JOINED TOGETHER ( ).
Do not climb, sit on, or use this product as a ladder due to possible injuries. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock is possible. Do not place this product on a slope that exceeds 10 degrees. If your display does not have casters, do not move this display after product is in place. Damage to display and injuries may occur. If your display does have casters, once in place, all casters must be locked to prevent movement.
