EC3001 flat mate end cap display ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before beginning to assemble this display. Save instructions for future reference. P.O. Box 458 27725 Danville Avenue Castle Rock, MN 55010 www.poly-tex.com REV: AA-120319 U.S.
PARTS IDENTIFICATION EC2015 BOTTOM BENCH (1) EC2013 END CAP BASE (1) NB1848 5/16" x 2" HEX BOLT (4) NB1763 1/4" x 1" HEX BOLT (1) NB1872 5/16" HEX NUT (7) NB1870 1/4" HEX NUT (1) EC2005 END CAP TOP BENCH (1) EC2016 MIDDLE BENCH (1) EC2017 BENCH SUPPORT (1) EC2014 END CAP VERTICAL (1) NB1862 5/16" LOCK WASHER (7) NB1860 1/4" LOCK WASHER (1) NB1850 5/16" x 2-1/2" HEX BOLT (3) TOOLS & EQUIPMENT REQUIRED 7/16", 1/2", and 9/16" open end wrenches and an adjustable wrench are required to assemble thi
ASSEMBLY INSTRUCTIONS 1. SLIDE END CAP VERTICAL INTO THE END CAP BASE. FASTEN WITH 5/16" x 2" HEX BOLT, LOCK WASHER, AND HEX NUT. 2. SLIDE THE BOTTOM BENCH OVER END CAP VERTICAL. ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" x 2" HEX BOLT, LOCK WASHER, AND HEX NUT. 3. SLIDE THE MIDDLE BENCH OVER END CAP VERTICAL. ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" x 2" HEX BOLT, LOCK WASHER, AND HEX NUT. DETAIL A 4. SLIDE END CAP TOP BENCH OVER END CAP VERTICAL. ALIGN WITH MOUNTING HOLE.
SAFETY GUIDELINES Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. CARE & MAINTENANCE To remove loose soil and debris, simply spray the soiled areas with water from a garden hose.
