2 level end cap ASSEMBLY INSTRUCTIONS EC2000 IMPORTANT Please read these instructions carefully before beginning to assemble this display. Save instructions for future reference. P.O. Box 458 27725 Danville Avenue Castle Rock, MN 55010 www.poly-tex.com REV: AA-120319 U.S.
PARTS IDENTIFICATION EC2004 END CAP MIDDLE BENCH (1) EC2011 END CAP BOTTOM BENCH (1) EC2001 END CAP BASE (1) EC2007 END CAP VERTICAL (1) EC2012 BOTTOM BENCH SUPPORT (1) NB1850 5/16" x 2-1/2" HEX BOLT (2) NB1763 1/4" x 1" HEX BOLT (1) NB1848 5/16" x 2" HEX BOLT (3) 1/4" LOCK WASHER (NB1860) QTY (2) NB1862 5/16" LOCK WASHER (5) 1/4" HEX NUT (NB1870) QTY (2) NB1872 5/16" HEX NUT (5) TOOLS & EQUIPMENT REQUIRED 2 7/16", 1/2", and 9/16" open end wrenches and an adjustable wrench are required to assem
ASSEMBLY INSTRUCTIONS 1. SLIDE END CAP VERTICAL INTO THE END CAP BASE. FASTEN WITH 5/16" HEX BOLT, LOCK WASHER, AND HEX NUT. 2. SLIDE END CAP BOTTOM BENCH OVER END CAP VERTICAL. ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" HEX BOLT, LOCK WASHER, AND HEX NUT. 3. SLIDE END CAP MIDDLE BENCH OVER END CAP VERTICAL. ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" HEX BOLT, LOCK WASHER, AND HEX NUT.
SAFETY GUIDELINES Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. CARE & MAINTENANCE To remove loose soil and debris, simply spray the soiled areas with water from a garden hose.
