357 circle display ASSEMBLY INSTRUCTIONS CD3570 IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference.
PARTS IDENTIFICATION CD3573 CIRCULAR SHELF (3') CD3571 CIRCULAR HALF SHELF (7') CD3574 VERTICAL 54 3/4" NB1968 SNAP PIN NB1850 5/16" x 2 1/2" HEX BOLT CD3572 CIRCULAR SHELF (5') NB1862 5/16" LOCK WASHER NB1978 5/16" x 3/8" SET SCREW NB1979 WRENCH HEX 5/32" TOOLS & EQUIPMENT REQUIRED 1/2" SOCKET AND 1/2" WRENCH 2 NB1872 HEX NUT 5/16" ZP
ASSEMBLY INSTRUCTIONS 1. LAY THE 7' HALF SECTIONS FACE DOWN ON A FLAT SURFACE. 2. USE 5/16" x 2 1/2" HEX BOLTS, LOCK WASHERS, AND NUTS TO CONNECT THE SECTIONS TOGETHER THEN TIGHTEN SECURELY.
ASSEMBLY INSTRUCTIONS 3. INSERT THE SNAP PIN IN THE HOLE OF THE VERTICAL AS SHOWN. 4. CAREFULLY TURN THE 7' SHELF UNIT OVER AND INSERT THE VERTICALS INTO THE SOCKETS WITH THE BLACK PLUG ON THE BOTTOM AS SHOWN.
ASSEMBLY INSTRUCTIONS 5. INSERT THE VERTICALS THROUGH THE 5' CIRCULAR SHELF UNTIL THE SHELF RESTS ON THE SNAP PINS.
ASSEMBLY INSTRUCTIONS 6. TIGHTEN THE SHELF TO THE VERTICALS USING THE SET SCREW & WRENCH PROVIDED.
ASSEMBLY INSTRUCTIONS 7. INSERT THE 3' SHELF INTO THE VERTICALS AS SHOWN MAKING SURE IT RESTS ON TOP OF THE VERTICALS.
SAFETY GUIDELINES Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. CARE & MAINTENANCE To remove loose soil and debris, simply spray the soiled areas with water from a garden hose.