HG2000 potting bench ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. HG2000 v1.0.
NT1009 10" x 44" UPPER SHELF (1) NT1000 24" x 44" TABLE TOP (1) NT1013 43" LEG (2) NT1003 30" LEG (2) NB1970 CAP SCREW (12) NB1974 3/16" HEX WRENCH (1) NB1862 LOCK WASHER (12) NB1886 FLAT WASHER (12) NB1872 HEX NUT (12) 3/16" hex wrench (included) & 1/2" open-end wrench are required to assemble this product.
0" LEG CAP SCREW HEX NUT FLAT WASHER LOCK WASHER 1. PLACE 30" (SHORTER) LEGS INSIDE TABLE TOP AS SHOWN. 2. FASTEN TO TABLE TOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. DO NOT TIGHTEN AT THIS TIME. SHELF IS ON OUTSIDE OF 43" LEGS LEG IS ON OUTSIDE OF TABLE TOP 3. PLACE 43" (LONGER) LEGS OUTSIDE OF TABLE TOP AS SHOWN. 4. FASTEN TO TABLE TOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. DO NOT TIGHTEN AT THIS TIME. 5.
Do not climb, sit on, or use this product as a ladder. Injuries may occur. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur. Do not place this product on a slope that exceeds 3 degrees. Do not move this display after product is in place. Damage to display and injuries may occur. Lock casters (when provided) once display is in place to prevent movement. Remove all debris or obstacles from caster's path before moving.
