Specifications

PO Box 409 • Hanover, MD 21076 • Tel [phone] • www.polyplanar.com
- 2 -
Controls, Input and Output Cables:
The switches and gain settings are located behind a watertight plug, which
also lights up when the amplifier is on. Be sure to replace the plug when
finished with adjustments
1) Input A Level. This rotary control selects the input sensitivity of the
amplifier’s RCA input (#4). Often referred to as Gain Control
2) Pilot Lamp: (Green) Illuminates when MZ100 is operating.
3) Equalization: These DIP switches are used to set one of eight different
equalization settings as shown on page 5.
4) Input A: Stereo RCA audio input for connecting other audio devices
5) Volume Control: Plug for the waterproof remote volume control. When
installed, this control will turn off the MZ100 Amp when turned all the way
down.
6) Audio System Connection: This plug is used for hooking the MZ-100 to
an extended poly-planar audio network using an RT20 System Router.
7) Control Panel Connection: This plug is used for hooking the MZ-100 to
poly-planar displays and control panels.
Figure 6 – Amplifier Switch and Gain settings
Left Panel View