Operation Manual

LECOASPIRA PROGRAM

ENGLISH

♦ Open the monoblock socket door (9), insert the monobloc plug (A6) of the flexible hose (A) pu-

shing it until you hear the click of the hooking mechanism (A7) (Fig. 6-6a).

♦ Connect the power plug to a suitable electric socket.

♦ If the appliance is switched off: Switch it on by pressing the main switch (1).

♦ When it is turned on, the appliance starts in manual mode MA.

ADJUSTMENT OF THE SUCTION LEVEL

By simply pressing the button (A4) you can select the suction power according to the type of sur-

face you are cleaning.

♦ By increasing the suction power, the sections of the indicator (8C) increase.

♦ when reducing the suction power, the segments decrease.

♦ To stop the suction press the key (A4).

When the appliance is switched on again, the suction level will be that set last time it was

used.

IN CASE OF AUTOMATIC STOP

When the dirt sucked into the water container (20) reaches the maximum allowed level, suction will

be automatically blocked by the special safety float. This can also occur when the water in the con-

tainer is very dirty. In these cases, there is an increase in the motor rpm and after 10 seconds the ap-

pliance automatically pauses; the suction speed lights (8C) and the suction light (8E) flash. When this

occurs, the water must be replaced in the container.

Turn off the appliance and only restart it when the level of the water in the container has been re-

stored as described in the chapter “Emptying and cleaning the dirt container.”

Any immediate restarting when the appliance has gone into pause mode can damage the air outlet

filter.

SWITCHING ON

NOTE

Level 1 curtains

Level 2 sofas and cushions

Level 3 carpets

Level 4 bare floors or to clean up liquids

HOW TO USE: SUCTION

LECOASPIRA PROGRAM - M0S10133 - 1T10:Layout 1 23/10/2013 9.45 Pagina 46