Operation Manual

| 34 |
26. TROUBLESHOOTING - TIPS
PROBLEM CAUSE SOLUTION
The appliance does not start No power
Check that the appliance has been disconnec-
ted from the mains, as indicated in Section 1.
Suction power is decreased
Nozzle, flexible suction
hose or rigid suction
hose are clogged.
HEPA filter is blocked or dirty
Turn the appliance off and unplug it. Clean
the filter and remove any blockages of tubes
and accessories.
Proceed as described in Chapter 23.
Water leaks out when vacuuming liquids Float blocked. Clean the water filter assembly.
The appliance is pressurized but little
steam comes out
The steam adjustment handle is on
Level 1
Turn the steam adjustment handle to increase
the flow of steam
The extension tubes and the accessories
are loose
The locknut is OPEN
Turn the locknut to the CLOSED position as
indicated in Chapter 2.
The appliance won’t dispense steam
Boiler turned off
No water in the tank
Steam lock activated
The boiler is not yet pressurised
Monobloc plug not inserted
correctly
Turn on the boiler
Add water to the tank as described in
Chapter 18
Disconnect the steam lock on the handle
Wait for the steam indicator light to stop
flashing
Insert the monobloc plug correctly.
Steam is dispensed mixed with drops of
water
The steam hose and/or the
telescopic tube are cold
Direct the steam jet onto a cloth to heat up
the tubes
Loss of steam or drops of water between
the connection of the accessories.
The seals are damaged. Replace the seals, as indicated in Chapter 24.
ENGLISH
PRELIMINARE LECOASPIRA FAV70_80 - 2015_vers7:UNICO 04/05/2015 17.28 Pagina 34