Operation Manual

| 31 |
10.2 For steam cleaning and suction use the nozzle for frames (7)
with the cap cloth (9) attached and connect it to the handle (1)
or to the extension tubes (3).
10.3 Follow the instructions provided in points 4.1 and 4.2.
Ensure that the steam lock on the handle is deactivated.
10.4 It is possible to use the suction and steam features either
together or by alternating them, activating both as described in
the previous points.
Combined use of steam and suction allows the most efficient
sanitising of the surface, dissolving dirt and removing grease,
germs and mites; it allows brightens the colour of fibres and
dries surfaces more quickly.
10.5 For model select Programme P6, as
indicated in Chapter 3.
Wait for the indicators to remain lit. This
programme is ideal for eliminating mites, and
vacuuming hair, animal fur and dust.
Intermittent jets of steam are supplied and at the
same time suction begins.
When the steam button is released the flow of steam stops,
while suction will continue for a few seconds more to dry the
surface treated. Suction stops automatically after a period of
time in proportion to the time the steam was supplied.
If you need to restart the programme to complete cleaning of
the surface, just press the steam button again.
In any case, it is possible to stop the programme manually by
pressing the suction button.
11. CLEANING BATHROOM FIXTURES,
GROUTING AND KITCHEN WORKTOPS
Make sure that you have prepared the appliance following the
instructions provided in Chapter 1.
11.1 Connect the concentrator accessory (4) equipped with bristly
round brush (5) to the handle (1). The steam lance (6) can be
attached to the concentrator accessory (4). This is recommended
for reaching the most difficult areas, ideal for cleaning radiators,
door and window frames, bathrooms and shutters.
To connect the steam lance (6) to the concentrator accessory
(4) just screw it on like the coloured brushes, which can be
screwed onto the lance and/or onto the accessory directly.
11.2 Turn on the boiler and adjust the strength of the steam
following the instructions provided in point 4.2.
11.3 Ensure that the steam lock is deactivated and press and hold
the steam trigger on the handle to begin cleaning.
11.4 Connect the suction lance (11) to the concentrator accessory
(4) and activate the suction function to begin vacuuming
immediately, removing dirt thanks to the concentrated steam jet.
12. CLEANING FURNITURE AND DELICATE
SURFACES
12.1 Connect the suction lance (11) or the nozzle for frames (7)
to the handle and press the suction button on the appliance.
12.2 Turn on the boiler and adjust the strength of the steam
following the instructions provided in point 4.2.
Press and hold the steam trigger on the handle and direct the
jet onto a cloth.
12.3 Use the cloth previously steamed to clean the surface,
avoiding prolonged use on the same spot.
13. OTHER GENERAL USES
13.1 BRIGHTENING UP CURTAINS AND DRAPES
Mites and dust can be removed from curtains and drapes by
steaming the fabric with just the handle. The steam is able to
remove odours and brighten up colours, allowing the fabric to
be washed less frequently.
For this surface, set the steam to level 1.
13.2 REMOVING STAINS FROM CARPETS AND UPHOLSTERY
Connect the concentrator accessory (4) without the bristly
round brush; direct the steam directly onto the stain with the
greatest angle possible (never vertically to the surface to be
cleaned) and place a cloth beyond the stain to collect the dirt
that has been “blown” away by the steam pressure.
For this surface, set the steam to level 1.
Connect the suction lance (11) to the concentrator accessory (4)
and activate suction to begin vacuuming the dirt removed which
has remained on the floor.
13.3 TAKING CARE OF PLANTS AND HUMIDIFYING ROOMS
To take care of your house plants, remove the dust from the
leaves using just the handle, vacuuming the surface: adjust the
steam to level 1 and vacuum at a distance of 50 cm. Plants
breathe better and will be cleaner and brighter. Furthermore,
you can also use the steam to refresh spaces, especially those
frequented by smokers.
WARNING: Steam.
Risk of scalding!
WARNING: Before cleaning the surface, always do a test on a
hidden part and see how it reacts to the application of steam.
WARNING: Do not direct the steam jet directly onto surfaces.
Before cleaning the surface, always do a test on a hidden part
and see how it reacts to the application of steam.
FAV80
The suction speed and the quantity of steam are preset and
therefore they cannot be adjusted manually.
Before steaming surfaces, we recommend vacuuming up any
hair or dust, using the vacuum only function in manual mode.
The different coloured brushes allow for a different colour for
each surface or environment.
ENGLISH
PRELIMINARE LECOASPIRA FAV70_80 - 2015_vers7:UNICO 04/05/2015 17.28 Pagina 31