Operation Manual

| 33 |
20.3 Bend and break the phial cap.
20.4 Pour the contents of the phial into the water filter collector
of the appliance.
21. GENERAL MAINTENANCE
To clean the outside of the appliance, only use a damp cloth
and tap water.
All accessories can be cleaned using running water, ensuring
they are completely dry before the next use.
Do not use detergents of any type.
22. CLEANING THE WATER FILTER COLLECTOR
(ordinary maintenance)
22.1 Ensure that the appliance is switched off and disconnected
from the mains.
22.2 Lift the water filter collector removing it from its housing
using the special handle.
22.3 Turn the handle backward and remove the water filter unit.
22.4 Empty the tank by tilting it towards the spout (14).
22.5 Turn the elbow tube downward until it slides off the filter
unit (15).
22.6 Separate all the components and rinse them under running
water.
22.7 Dry the various components of the filter, reassemble it and
reinsert it into the dirt collector.
22.8 Reposition the water filter collector in the appliance.
23. CLEANING THE HEPA FILTER
(extraordinary maintenance)
23.1 Ensure that the appliance is switched off and disconnected
from the mains.
23.2 Lift the water filter collector removing it from its housing
using the container handle.
23.3 Lift the release lever of the HEPA filter and remove it from
its housing.
23.4 Rinse the HEPA filter using running water only and shake
gently to remove any excess dirt or water residue; before
replacing the filter in the appliance, leave to dry naturally away
from sources of heat for at least 24 hours.
The HEPA filter should be fully cleaned approximately three
times per year.
24. SPARE SEALS
Periodically check the status of the coloured washer located in
the built-in socket. If necessary, replace with the corresponding
spare part, as described below.
Perform the same check on the connection seals of the
extension tubes and the handle of the hose. If necessary,
operate as follows.
25. STORAGE
25.1 Turn off the appliance and disconnect from the mains
electricity.
25.2 Remove the water filter collector as indicated in Chapter 1.
25.3 Manually wind the cable evenly and replace it into the
holder, passing it into the power cable storage space.
25.4 Replace the water filter collector in its housing, making
sure to position it correctly.
25.5 The hoses, brush and flexible hose can be housed on the
body of the appliance, sliding the hook on the universal brush
into the parking system on the appliance.
The hook is present only on extension tubes. Incorrect
assembly of the two extension tubes will prevent the use of
the appliance parking system.
- Remove the damaged washer.
- Insert the new washer, applying it on the
steam nozzle and pushing it into place.
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oil.
- Remove the damaged washer.
- Insert the new washer, attaching it on the
steam nozzle and pushing it into place.
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oils.
WARNING: Do not clean the filter with the brush as it can be
damaged, thereby reducing its filtering capacity. Do not use
detergents, do not rub the filter, and do not wash it in a
dishwasher.
WARNING: Check the filters during cleaning. Replace the filters
when visibly damaged.
Use 1 phial per use.
A possible change in the colour of the liquid does not alter the
functioning or the efficacy of the product
WARNING: Never poor Bioecologico into the boiler.
WARNING: Check the filters during cleaning. Replace the filters
when visibly damaged.
To clean the water filter collector and the extension tubes, if
they are especially dirty, once the cleaning operations have
been completed, empty the container as described and
replace it in its housing in the machine. Connect the appliance
to the mains.
Then vacuum up approximately 1.5 litres of clean water using
the suction function for a few seconds. The water vortex
created inside the collector will rinse the sides and remove any
dirt. The clean water will also clean the inside of the tubes as
it travels through them. Empty the collector again and put
Vaporetto Lecoaspira away.
ENGLISH
PRELIMINARE LECOASPIRA FAV70_80 - 2015_vers7:UNICO 04/05/2015 17.28 Pagina 33