Operation Manual

WINDOW CLEANER ACCESSORY (5)
+ SPONGE CAP (14)
By attaching the sponge cap, it is possible to tran-
sform the window cleaning accessory into a small
brush and to use it where it is impossible or incon-
venient to use the large brush.
SMALL ROUND BRUSH WITH BRASS BRI
-
STLES (6) - SMALL ROUND BRUSH WITH
NYLON BRISTLES (7) - LARGE ROUND BRUSH
WITH NYLON BRISTLES (9)
Recommended for removing encrusted dirt from
very narrow surfaces, such as hobs, blinds, bath-
room elements, etc.
ACCESSORY 120° (8)
Recommended for reaching inaccessible points,
thanks to its curved shape.
GROUT ACCESSORY (10)
Recommended for removing dirt from the grout
between tiles.
SPATULA (11)
Recommended for removing particular stubborn
encrusted dirt.
TRANSPORT
One of the great advantages of this appliance is
that it can be taken everywhere with the base (M)
with wheels (L) on your shoulder using the strap
(16).
To carry it with the base (M), make sure that it is
attached to the appliance.
To attach it, proceed as follows:
First insert the front part, then push the appliance
downwards until you hear the lever click (O) (Fig.
9). To release the base, press the lever downward
(O), and lift the appliance using the handle (B).
To carry it with the strap, make sure that the base
(M), is released from the appliance then hook the
carrying strap (16) to the two holes (F) (Fig.10)
ATTENTION: especially when the appliance has
just been filled, during cleaning and consequently
when moving the appliance, a small amount of
water may leak out mixed with the steam from the
accessories.
STORING THE DEVICE
It is possible to replace the appliance by resting the
brush (3) with the hoses (2) and flexible hose (1) in
the parking as shown in Fig. 13.
CARE OF YOUR APPLIANCE
• Before carrying out any maintenance on the devi-
ce, always unplug it from the power mains
making sure that the product has cooled down
before proceeding.
• After using the brushes, we recommend letting
the bristles cool down in their natural position, in
order to avoid any deformation.
• To clean the body of the appliance, simply use a
moist cloth.
• Clean accessories by rinsing them in running
water.
• Regularly check the status of the coloured
washer located in the connector assembly
(1F). If necessary, replace with the appro-
priate spare part (17), as described below.
- Remove the damaged washer.
- Insert the new washer, placing it on the steam
nozzle and pushing it until it is in its place. See
(Fig. C).
- Lubricate the gasket with silicone grease or Va-
seline, or alternatively with small quantities of ve-
getable oils.
Carry out the same inspection on the connection
seals of the steam gun (1C), the extension tubes
(2) and the accessories socket (4).
Fig. C
20
VAPORETTO go
ENGLISH
VAPORETTO GO - M0S10515 - 1T05 PRELIMINARE_vers7:FEV 1000-950.qxd 05/07/2013 10.08 Pagina 20