Operation Manual

ENGLISH
| 24 |
11. TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
If water comes out from the Iron
soleplate instead of steam
The pressure values have not been
reached
Check that the ready steam lamp is OFF indica-
ting that the Vaporella has reached the right
pressure
Wait until the required temperature and pres-
sure are reached as shown by the indicator
lights.
The temperature knob on the iron is
set at the minimum value.
Adjust the temperature knob on the iron to the
medium/maximum vaue.
First steam release. Release onto a cloth until steam comes out
from the holes on the solepate.
Steam does not come out from
the Iron soleplate
ON-OFF button and boiler button
off.
Make sure that the appliance is powered and
that the power ON-OFF and boiler button are
on
Water tank is empty. Fill the water tank.
Little steam comes from the Iron
soleplate.
The steam regulation knob is set at
the minimum value.
Increase the steam flow by adjusting the steam
regulation knob to the medium/maximum
value.
The steam is dry, so is barely visible,
but is present and effective
This is normal especially in particular environ-
mental conditions.
The appliance does not turn on. ON/OFF switch turned off.
No power.
Press the ON/OFF switch.
Check that the appliance has been disconnected
from the mains, as indicated in Section 1.
Some water drops are present
on the fabric.
The cover used on the Ironing board
is wet since it cannot withstand the
power of the steam station.
Check that the shaft is suitable (shaft with grille
that prevents condensation).
Presence of water under the
appliance.
Boiler cleaning cap screwed on
incorrectly.
Seal of the boiler cleaning cap
damaged.
Unscrew the boiler cleaning cap and screw it back on
(Chapter 9).
Take Vaporella to an authorised service centre
Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com for the up-to-date list) or
Customer Services.
PRELIMINARE VL FOREVER 8.85-8.80 - 1P05_vers7:UNICO 17/07/2015 15.37 Pagina 24