Operation Manual

ENGLISH
| 22 |
11.5 Rinse the boiler and pour the water into the sink or into a
special container. If the water is very dirty, repeat the operation
until it is clean.
11.6 Put 100 ml of water in the boiler and screw back the cap.
Make sure that the seal is in and the cap is screwed on properly.
11.7 Fill the water tank again.
11.8 Reconnect the plug to the mains electricity (3).
11.9 Holding down the steam button (7) turn the appliance on
with the ON/OFF switch (3). Hold the steam button down until
the indicator light stays on ( ).
11.10 Now the appliance can be used normally again.
12. STORAGE
12.1 Turn off the appliance and disconnect from the mains
electricity.
12.2 Wait for the appliance to cool down completely before
storing it.
12.3 Empty the water tank.
12.4 Position the monotube in the special housing located on
the side of the appliance (13).
12.5 Insert the power supply cable into the special cable
compartment (14).
12.6 Move Vaporella, using the carrying handle (15)-(16).
WARNING: Before moving Vaporella with the handle, make
sure that the power supply cable and monotube have been
stored as described in Point 12.4 - 12.5.
The lighting of the three “Calc control” indicator lights disables
the boiler and the iron. In order to be able to continue ironing,
the boiler needs to be cleaned.
However, it is possible to postpone the cleaning by holding
down the steam button for at least two seconds (7). The next
time the appliance is switched on, the three indicator lights
will start to flash again, indicating that the boiler still needs to
be cleaned.
preliminare VL SILENCE FRIENDLY 14.45-14.55-19.50-19.55 - M0S11301 - 1P09:UNICO 29/09/2015 12.09 Pagina 22