®
VAPORELLA 3 1 3b 3a 4 6 2 7 9 8 5 Fig. 1 Fig. 2 Fig. 3 Fig.
VAPORELLA 1) Iron temperature adjustment knob 2) Boiler ON/OFF switch 3) Steam button 3a) “Iron heating” indicator light 3b) Continuous steam jet button 4) Iron on/off switch 5) Patented safety cap 6) Iron rest 7) Power cable 8) Monotube (cable + steam tube) 9) Filler funnel Polti S.p.A. reserves the right to change equipment or accessory specification without prior notice. This unit conforms with EC-directives 89/336 as amended by 93/68 (EMC) and 73/23 as amended by 93/68 (low voltage).
VAPORELLA • • • • • • • appliance, use only original spare parts and accessories approved by the manufacturer. Do not wind the power cord around the appliance, especially when the appliance is still hot. During refilling with water, switch off and disconnect the appliance from the mains. It is necessary to keep the unit in horizontal position during operation. Do not direct the steam jet on electrical appliances. Leave the appliance to cool down before cleaning it.
VAPORELLA • Polti declines liability for any damage or accident derived from any use of VAPORELLA which is not in conformity with the instructions contained in this booklet. few drops of water mixed with steam may come out of the soleplate until the temperature stabilises. It is advisable to direct the first jets of steam onto an old cloth until a uniform stable jet of steam is obtained. P R E PA R AT I O N F O R U S E 1a. Unscrew the patented safety cap (5) and fill the boiler with about 0.
VAPORELLA 6d. Wait for a few minutes to allow the generator tank to cool down. 7d. When cool, proceed to carefully refill the tank as described in paragraph 1a of the section “PREPARATION FOR USE” in the instructions. If refilling the generator when not completely cooled, we recommend that you carefully pour only very small quantities of water at each pouring into the tank, so as to avoid spitting from the tank.
