Operation Manual
ENGLISH
VAPORELLA FOREVER 1905 ECO PROGRAM
30
plate. Release the button and the steam flow
stops.
NOTE: during initial operation of the iron, a
few drops of water mixed with steam may
come out of the soleplate until the tempera-
ture stabilises. It is advisable to direct the first
jets of steam onto an old cloth until a uniform
jet of steam is obtained.
• In order to have a continuous steam jet, move
the button (10a) forwards. Steam will keep on
coming out, even releasing the steam request
button. To interrupt the outlet, move the button
(10a) backwards (fig.4).
NOTE:
• The “Iron heating” indicator light (11) turns on
and off during use. This indicates that the
electrical resistor has started to work to keep
the temperature in the iron steady. This is a
normal occurrence, and it is therefore possi-
ble to continue ironing.
ECO function
Set the programme by turning the selection dial
(6) corresponding to the "ECO" indication.
With the ECO function on, the appliance sets itself
to a medium level of both steam pressure and iron
temperature, thereby optimising consumption
whilst ensuring optimum ironing of the hardest-
wearing fabrics (cotton / jeans / linen).
Do not use this mode for ironing synthetic,
silk and wool clothing
SHORTAGE OF WATER
The lack of water in the tank (3) is signalled by
the indicator light (C) coming on.
To return to ironing, proceed as follows:
• Fill the tank (3) again, as described in the pa-
ragraph “PREPARATION”.
• Press the "RESET" (5) (Fig5) key to turn off
the no water light (C).
PUTTING AWAY THE APPLIANCE
Make sure the appliance has cooled down com-
pletely before putting it away.
• Tug on the power cable gently (9) until it
clicks once, and then accompany it with your
hand as it is automatically wound up by the
cable winder (9a).
• Position the flex (steam and electric) (7) in the
specific housing (8) (fig. 6).
• Carry the Vaporella by its convenient carry
handle (1) (fig.6).
ATTENTION:
before moving Vaporella by its
carry handle, ensure that you have replaced the
power supply cable (9) and flex (steam and
electric) (7) as described previously.
ENERGY SAVING
STAND-BY FUNCTION
After 10 minutes of the appliance not being
used, it automatically goes into stand-by mode.
Both the boiler and iron are switched off.The in-
dicator lights (A), (B) and (C) flash simultaneou-
sly.
To re-activate the appliance, press the steam
request button (10).
N.B.: The stand-by function will not be applied if
the selection dial (6) is set to "SYNT SILK DRY".
The symbol on the label means:
do not iron
VL FOREVER 1905 ECO P. M0S10166 1S02_7:FEV 1000-950.qxd 09/03/2012 9.52 Pagina 30