Operation Manual

ENGLISH
PUTTING AWAY THE APPLIANCE
Before replacing the appliance, make sure that it
has cooled completely.
• Gently pull the power supply cable (9) until
you hear the first click and, guiding it, allow it
to automatically wind around the reel (Fig. 3).
• Position the monotube (7) in the specific hou-
sing (10) (Fig. 6).
• To move Vaporella, use the practical carrying
handle (3) (fig. 7).
ATTENTION:
before moving Vaporella with the
handle, make sure that the power supply cable
(9) and monotube (7) have been stored as de-
scribed previously.
ENERGY SAVING
STAND-BY FUNCTION
After 10 minutes without use, the appliance au-
tomatically goes into stand-by mode, switching
off both the boiler and iron.
The indicator (8d) will start to flash.
To re-activate the appliance, press the steam re-
quest button (4) for at least 1 second.
CARE OF YOUR VAPORELLA
• Before attempting any maintenance opera-
tion, always disconnect the appliance from
the mains.
• To clean the body of the appliance, simply use
a moist cloth. Do not use solvents or deter-
gents which may harm the body material.
19
VAPORELLA FOREVER 1800 ECO PROGRAM
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The on indicator (8d) is off.
Power supply cable (9) not inser-
ted
Main switch (1) is off
Connect the power supply cable (9)
to a suitable electric socket.
Turn on the main switch (1).
The appliance is on but it is not
producing steam
Water tank (2) is empty or not in-
serted correctly.
The SYNT SILK OFF function is
activated
Fill the water tank (2).
Make sure the water tank is inserted
correctly.
Change function with steam ironing.
The Add Kalstop indicator light
(8b) stays on.
You need to add Kalstop
The auto-Kalstop function has
not been reset
Add Kalstop
Reset the function.
In both cases follow the instructions
in the “AUTO-KALSTOP FUNCTION”
section.
During the heating phase, the
indicators (8a - 8c - 8h - 8l),
turn on one at a time clockwi-
se.
The appliance does not reach
the pressure selected.
Turn the machine off then turn it back
on.
If, after this operation, the problem
persists, turn the machine off and
take it to an Authorized Service Cen-
tre.
The indicators (8a - 8c - 8h -
8l) all flash together.
Fault in the electrical system.
Turn the machine off then turn it back
on.
If, after this operation, the problem
persists, turn the machine off and
take it to an Authorized Service Cen-
tre.
VL FOREVER 1800 ECO PROGRAM - M0S10337 - 1T02:FEV 1000-950.qxd 01/03/2013 15.53 Pagina 19