Operation Manual
E
E
N
N
G
G
L
L
I
I
S
S
H
H
71
LECOASPIRA INTELLIGENT
M
M
A
A
N
N
U
U
A
A
L
L
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
• Press the main switch (1): the appliance will
come on in manual or “MA” mode.
In this mode you can manually adjust the
amount of steam to be dispensed and the suc-
tion speed.
STEAM
• Press UP (4) to turn on the boiler. Each time
you press the UP button (4) again steam
pressure will increase. Every time you press
the UP button (4) one of the steam pressure
indicator lights (8B) will come on.
• DOWN (5) has the opposite effect: every
time you press it steam pressure decreases
and one of the indicator lights (8B) goes off.
• If you wish to turn off the boiler, press DOWN
(5) until all the indicator lights (8B) go off.
Strong steam: (4 indicators on)
to remove stubborn deposits, stains and
grease or to sanitise;
Normal steam: (2 or 3 indicator lights on)
for rugs, carpets, glass, floors;
Gentle steam: (1 indicator light on)
to spray plants, clean delicate fabrics, wallpa-
per, sofas, etc.
• When the boiler comes on the indicator lights
(8B) and (8F) will flash. When the boiler indi-
cator light (8F) stays on, this means the ap-
pliance has reached the minimum pressure
for dispensing steam. Wait until the other in-
dicator lights (8B) also stop flashing, mea-
ning that steam pressure has reached the
selected pressure.
• Press the Steam request button (A5) on the
handle to dispense steam.
Indicator light (8D) comes on when steam is
being dispensed.
SUCTIONING
You may adjust suction power to suit the sur-
face to be cleaned: the numbers correspond to
segments in the indicator light (8C) on.
1 for curtains
2 for sofas and cushions
3 for carpets
4 for hard floor surfaces and to suction up liq-
uids
Using suction controls
Simply press the suction button (A4) to start
vacuuming.
Hold down the suction button (A4) to select
the appropriate speed for the surface to be
cleaned. As suction power increases, the
number of indicator segments lit up will
increase (8C); as suction power deceases the
number of segments will decrease.
To stop vacuuming while the appliance is
turned on, simply press the suction button
(A4).
NOTE: When you start suctioning, the appli-
ance starts vacuuming at the speed it was set
to when it was last turned off.
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
P
P
1
1
:
:
R
R
U
U
G
G
S
S
/
/
C
C
A
A
R
R
P
P
E
E
T
T
S
S
• Connect the two extension tubes (D) to the
handle, and connect the multipurpose brush
(E) to them with the carpet attachment with
rigid inserts (E4).
• Wait until indicator lights (8B) and (8F) stop
flashing. At this point the appliance is ready
to dispense steam.
• Hold down the Steam request button (A5) to
dispense steam. When you release the but-
ton (A5) or after a maximum of 150 seconds
suctioning will start automatically to dry the
steam-cleaned surface.
• Suctioning automatically stops after an
amount of time proportionate to the amount
of time for which steam was dispensed. You
may stop the programme manually by pres-
sing the suction button (A4).
• When cleaning large surfaces, you may start
up the programme immediately upon com-
pleting the cycle to finish cleaning the entire
surface.
NOTE: suction speed and steam quantity are
preset and cannot be adjusted manually.
Vacuum up hair and dust in manual (MA) mode
before steam cleaning surfaces.
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
P
P
2
2
:
:
P
P
A
A
R
R
Q
Q
U
U
E
E
T
T
• Hold down the Steam request button (A5) to
dispense alternating steam cycles and start
suctioning. Release the button (A5) to stop
dispensing steam, while suctioning will conti-
nue for a few more seconds to allow the
steam cleaned surface to dry.
• To avoid damaging delicate surfaces, we
LECOASPIRA INTELLIGENT - M0S09384 1Q06:Layout 1 22/06/2010 11.25 Pagina 71