Operation Manual
door jambs, shutters, etc.
UPHOLSTERY NOZZLE (Q) *
recommended for cleaning fabric surfaces
such as the seams in sofas, armchairs, mat-
tresses.
NB DO NOT USE STEAM ON DRAYLON
OR SIMILAR DELICATE SURFACES
SUCTION BRUSH (T) *
recommended for dusting delicate surfaces
such as frames, books, etc. using soft bris-
tles.
LANCE (R) *
recommended for deep cleaning of difficult
spots such as skirting boards, folds in sofas,
armchairs.
NB DO NOT USE STEAM ON DRAYLON
OR SIMILAR DELICATE SURFACES.
Attach radiator brush (S) to the tip of the
lance (R) to clean and remove accumulated
dust, eg from gaps in radiators.
JOKER BRUSH (F) *
With the Joker brush it is possible to remove
all types of solid or liquid dirt, and it works on
any type of surface.
PARQUET ACCESSORY (G) *
This accessory is for use with the Joker
brush only. Put the joker brush into place on
the parquet accessory as illustrated in fig.12.
Apply the brush to the accessory as indi-
cated by the arrow so that the two pieces fit
onto each other and then hook them to-
gether. To unhook the parquet accessory
from the joker brush pull the two levers on
the sides of the fitting outwards and then lift
the brush off (Fig. 13).
*OPTIONAL
G
G
E
E
N
N
E
E
R
R
A
A
L
L
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
Before carrying out any type of maintenance
make sure that the power cable has been
disconnected from the mains.
After using the brushes it is advisable to al-
low the bristles to cool in their natural posi-
tion so as to avoid them getting deformed in
any way.
Check the conditions of the gaskets located
inside the monobloc plug (B2) periodically. If
necessary, replace them with the the autho-
rised spares. Also carry out the same check
on the gaskets for connecting the extension
tubes (D) and the handle (A2). To clean the
outside of the appliance, just use a damp
cloth. Do not use solvents or detergents as
these might damage the plastic surface. To
clean the “ECOACTIVE-FILTER” holder and
clean or change the sponge filter, follow the
instructions in the paragraph headed “EMP-
TYING AND CLEANING THE DIRT CON-
TAINER”.
PPI FILTER (17)
Proceed as follows to clean the PPI filter and
replace it when necessary:
• Open the PPI filter lid (18) on the bottom
of the appliance (fig.14).
• Remove the PPI filter (17) from its hou-
sing.
• Rinse the filter under running water, let it
dry and then put it back in place.
Replace the filter if it is torn.
VAPORETTO ASPIROVAPOR
50
E
E
N
N
G
G
L
L
I
I
S
S
H
H
VT ASPIROVAPOR M0S09205 1Q03_RO_vers7:Layout 1 27/05/2010 10.31 Pagina 50