User Manual

8
USING THE HIGH-PASS FILTER
The high-pass lter attenuates noise below 80 Hz. This helps prevent the microphone from recording low-
frequency noises like the rumble of an air conditioner, blower, or fan.
To turn on the high-pass lter, slide the switch on the microphone to the L-CUT position. To turn off the high-
pass lter, slide the switch to the FLAT position.
RECORDING
1. Plug the 3.5 mm stereo mini connector into the audio input jack of your camera or portable recorder.
2. Place the foam windscreen over the microphone.
3. Slide the power/high-pass lter switch to the FLAT or L-CUT position.
4. You are now ready to record. Consult the instructions of your camera or recording device for directions on
recording.
Important: Turn off the Auto Gain Control in your camera settings before recording.