Data Sheet

For encoder control modes, this determines the number of encoder counts per unit change of the
stepper motor position or speed, as described in Section 5.3.
Encoder postscaler
Offset 0x37
Type unsigned 32-bit
Default 1
Range 1 to 2,147,483,647
Settings file encoder_postscaler
Tic Control Center Input and motor settings tab, Encoder box, Postscaler
For encoder control modes, this determines the size of a unit change in the stepper motor position or
speed, as described in Section 5.3.
Enable unbounded position control
Offset 0x5C
Type unsigned 8-bit
Data
• 0: false
• 1: true
Default false
Settings file encoder_unlimited
Settings file data false or true
Tic Control
Center
Input and motor settings tab, Encoder box, Enable unbounded position control
This setting is described in Section 5.3.
Tic Stepper Motor Controller User’s Guide © 2001–2018 Pololu Corporation
6. Setting reference Page 96 of 150