Manualshelf

Data Sheet

ManualsBrandsPololu ManualsStepper Motor ControllersT834 USB Multi-Interface 2.5-10.8V, 1.5A Stepper Motor Controller (Soldered)
131132133134135136137138139140
does not have any of the other effects of the “reset” command, instead applying the new settings
seamlessly if possible. This command is not available on the TTL serial and I²C interfaces.
Start bootloader (USB only)
Command 0xFF
Format Quick
Data none
This command causes the Tic to start its bootloader in preparation for receiving a firmware upgrade
over USB. It is not available on the TTL serial and I²C interfaces.
Tic Stepper Motor Controller User’s Guide © 2001–2018 Pololu Corporation
8. Command reference Page 134 of 150