Data Sheet

The P-Star 25K50 Micro connected to a PICkit 3 programmer and a reset button.
Another option for connecting a P-Star 25K50 Micro to a PICkit is to solder upwards-pointing header pins on all
five programming pins, as shown below. The PICkit 3 can then be directly connected to this five-pin header, or it
could be connected through a set of male-female premium jumper wires [https://www.pololu.com/category/67/male-
female-premium-jumper-wires]. This configuration of header pins prevents the MCLR pin from plugging directly
into a breadboard, but it could still be connected via a jumper wire.
Pololu P-Star 25K50 Micro Users Guide © 2001–2017 Pololu Corporation
7. Programming using the PICkit 3 Page 27 of 38