Datasheet

return SPDR;
}
Related Links
Pin Descriptions
USARTSPI - USART in SPI Mode
Power Management and Sleep Modes
I/O-Ports
About Code Examples
23.3 SS Pin Functionality
23.3.1 Slave Mode
When the SPI is configured as a slave, the Slave Select (SS) pin is always input. When SS is held low,
the SPI is activated, and MISO becomes an output if configured so by the user. All other pins are inputs.
When SS is driven high, all pins are inputs, and the SPI is passive, which means that it will not receive
incoming data. The SPI logic will be reset once the SS pin is driven high.
The SS pin is useful for packet/byte synchronization to keep the slave bit counter synchronous with the
master clock generator. When the SS pin is driven high, the SPI slave will immediately reset the send and
receive logic, and drop any partially received data in the Shift register.
23.3.2 Master Mode
When the SPI is configured as a Master (MSTR in SPCR is set), the user can determine the direction of
the SS pin.
If SS is configured as an output, the pin is a general output pin that does not affect the SPI system.
Typically, the pin will be driving the SS pin of the SPI slave.
If SS is configured as an input, it must be held high to ensure master SPI operation. If the SS pin is driven
low by peripheral circuitry when the SPI is configured as a master with the SS pin defined as an input, the
SPI system interprets this as another master selecting the SPI as a slave and starting to send data to it.
To avoid bus contention, the SPI system takes the following actions:
1. The MSTR bit in SPCR is cleared and the SPI system becomes a slave. As a result of the SPI
becoming a slave, the MOSI and SCK pins become inputs.
2. The SPIF flag in SPSR is set, and if the SPI interrupt is enabled, and the I-bit in SREG is set, the
interrupt routine will be executed.
Thus, when interrupt-driven SPI transmission is used in Master mode, and there exists a possibility that
SS is driven low, the interrupt should always check that the MSTR bit is still set. If the MSTR bit has been
cleared by a slave select, it must be set by the user to re-enable SPI Master mode.
23.4 Data Modes
There are four combinations of SCK phase and polarity with respect to serial data, which are determined
by control bits CPHA and CPOL. Data bits are shifted out and latched in on opposite edges of the SCK
signal, ensuring sufficient time for data signals to stabilize. The following table summarizes SPCR.CPOL
and SPCR.CPHA settings.
ATmega328PB
SPI – Serial Peripheral Interface
© 2018 Microchip Technology Inc.
Datasheet Complete
40001906b-page 252