Data Sheet

Pololu RC Switch with Relay, labeled top view.
For the Pololu RC Switch with Relay, the learning mode jumper consists of two holes. You could use
a wire to connect the two holes, but we recommend inserting a 1×2-pin male header into the included
blue shorting block and using that as a tool to connect the two holes. The assembled version of the
switch comes with a 1×2-pin male header. If you have the partial kit version, you can break two pins
off of the included male header to get a 1×2-pin piece. To make the contact, stick the two exposed
pins into the two holes of the learning mode jumper and then tilt the tool towards the side and press
on it to ensure a good connection with the inside edge of each hole. It is not sufficient to just rest the
tool on the learning mode jumper; you must tilt it and apply some force.
Pololu RC Switch User’s Guide © 2001–2017 Pololu Corporation
9. Configuring Your RC Switch Page 42 of 45