Data Sheet

• The assembled version [https://www.pololu.com/product/2804] ships with the 5V Omron relay,
header pins, and terminal block soldered in. A 1×2-pin male header and a shorting block
are also included with the assembled version and can be used together as a tool when
configuring the device. The assembled version can be incorporated into an existing RC
system without the need for any additional soldering.
• The partial kit version [https://www.pololu.com/product/2805] gives you the flexibility to choose
different connections. It includes a 5V Omron relay, 0.1″ 12-pin male header, a 0.1″ 12-pin
right-angle male header, a 3-pin terminal block, and a shorting block. The headers can be
broken into smaller pieces and optionally soldered to the board, or wires can be soldered
directly to the board for the most compact installation.
Warning: When soldering the terminal block into the partial kit version, be sure to use
the larger set of holes. If you use the smaller holes, which are intended for 0.2″ male
header pins, there will not be enough space to mount the relay.
Pololu RC Switch with Relay
(Assembled) with included hardware.
Pololu RC Switch with Relay (Partial
Kit).
5.2. Connecting the RC Switch with Relay
The typical way to connect the Pololu RC Switch with Relay is shown in the diagram below:
Pololu RC Switch User’s Guide © 2001–2017 Pololu Corporation
5. RC Switch with Relay Page 28 of 45