VNH5019A-E datasheet
Table Of Contents
- 1 Block diagram and pin description
- 2 Electrical specifications
- Figure 3. Current and voltage conventions
- 2.1 Absolute maximum ratings
- 2.2 Thermal data
- 2.3 Electrical characteristics
- 2.4 Waveforms and truth table
- Table 11. Truth table in normal operating conditions
- Figure 4. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option A)
- Figure 5. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option B)
- Table 12. Truth table in fault conditions (detected on OUTA)
- Figure 6. Behavior in fault condition (how a fault can be cleared)
- Table 13. Electrical transient requirements (part 1)
- Table 14. Electrical transient requirements (part 2)
- Table 15. Electrical transient requirements (part 3)
- 2.5 Reverse battery protection
- Figure 7. Definition of the delay times measurement
- Figure 8. Definition of the low-side switching times
- Figure 9. Definition of the high-side switching times
- Figure 10. Definition of dynamic cross conduction current during a PWM operation
- Figure 11. Waveforms in full bridge operation (part 1)
- Figure 12. Waveforms in full bridge operation (part 2)
- Figure 13. Definition of delay response time of sense current
- Figure 14. Half-bridge configuration
- Figure 15. Multi-motors configuration
- 3 Package and PCB thermal data
- 3.1 MultiPowerSO-30 thermal data
- 4 Package and packing information
- 5 Order codes
- 6 Revision history
VNH5019A-E Electrical specifications
Doc ID 15701 Rev 7 9/34
2.2 Thermal data
V
CS
Current sense maximum voltage
V
CC
- 41
+V
CC
V
V
V
ESD
Electrostatic discharge (human body model: R = 1.5 kΩ,
C = 100 pF)
2kV
T
c
Case operating temperature -40 to 150 °C
T
STG
Storage temperature -55 to 150 °C
1. This applies with the n-channel MOSFET used for the reverse battery protection. Otherwise V
BAT
has to be
shorted to V
CC
.
Table 3. Absolute maximum rating (continued)
Symbol Parameter Value Unit
Table 4. Thermal data
Symbol Parameter Max. value Unit
R
thj-case
Thermal resistance junction-case HSD 1.7 °C/W
Thermal resistance junction-case LSD 3.2 °C/W
R
thj-amb
Thermal resistance junction-ambient See Figure 18 °C/W