VNH5019A-E datasheet
Table Of Contents
- 1 Block diagram and pin description
- 2 Electrical specifications
- Figure 3. Current and voltage conventions
- 2.1 Absolute maximum ratings
- 2.2 Thermal data
- 2.3 Electrical characteristics
- 2.4 Waveforms and truth table
- Table 11. Truth table in normal operating conditions
- Figure 4. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option A)
- Figure 5. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option B)
- Table 12. Truth table in fault conditions (detected on OUTA)
- Figure 6. Behavior in fault condition (how a fault can be cleared)
- Table 13. Electrical transient requirements (part 1)
- Table 14. Electrical transient requirements (part 2)
- Table 15. Electrical transient requirements (part 3)
- 2.5 Reverse battery protection
- Figure 7. Definition of the delay times measurement
- Figure 8. Definition of the low-side switching times
- Figure 9. Definition of the high-side switching times
- Figure 10. Definition of dynamic cross conduction current during a PWM operation
- Figure 11. Waveforms in full bridge operation (part 1)
- Figure 12. Waveforms in full bridge operation (part 2)
- Figure 13. Definition of delay response time of sense current
- Figure 14. Half-bridge configuration
- Figure 15. Multi-motors configuration
- 3 Package and PCB thermal data
- 3.1 MultiPowerSO-30 thermal data
- 4 Package and packing information
- 5 Order codes
- 6 Revision history
Electrical specifications VNH5019A-E
8/34 Doc ID 15701 Rev 7
2 Electrical specifications
Figure 3. Current and voltage conventions
2.1 Absolute maximum ratings
Stressing the device above the rating listed in the “absolute maximum ratings” table may
cause permanent damage to the device. These are stress ratings only and operation of the
device at these or any other conditions above those indicated in the operating sections of
this specification is not implied. Exposure to absolute maximum rating conditions for
extended periods may affect device reliability. Refer also to the STMicroelectronics SURE
program and other relevant quality document.
V
CC
IN
A
GND
B
I
S
I
OUTA
I
INA
V
INA
V
CC
V
OUTA
I
SENSE
V
OUTB
DIAG
A
/EN
A
I
ENA
I
GND
I
OUTB
IN
B
I
INB
DIAG
B
/EN
B
I
ENB
V
ENB
V
ENA
V
INB
V
SENSE
OUT
A
OUT
B
PWM
CS
I
pw
V
pw
GND
A
GND
CP
V
BAT
I
BAT
V
BAT
V
CP
I
CP
CS_DIS
I
CSD
V
CSD
Table 3. Absolute maximum rating
Symbol Parameter Value Unit
V
BAT
Maximum battery voltage
(1)
-16
+41
V
V
V
CC
Maximum bridge supply voltage + 41 V
I
max
Maximum output current (continuous) 30 A
I
R
Reverse output current (continuous) -30 A
I
IN
Input current (IN
A
and IN
B
pins) +/- 10 mA
I
EN
Enable input current (DIAG
A
/EN
A
and DIAG
B
/EN
B
pins) +/- 10 mA
I
pw
PWM input current +/- 10 mA
I
CP
CP output current +/- 10 mA
I
CS_DIS
CS_DIS input current +/- 10 mA