VNH5019A-E datasheet
Table Of Contents
- 1 Block diagram and pin description
- 2 Electrical specifications
- Figure 3. Current and voltage conventions
- 2.1 Absolute maximum ratings
- 2.2 Thermal data
- 2.3 Electrical characteristics
- 2.4 Waveforms and truth table
- Table 11. Truth table in normal operating conditions
- Figure 4. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option A)
- Figure 5. Typical application circuit for DC to 20 kHz PWM operation with reverse battery protection (option B)
- Table 12. Truth table in fault conditions (detected on OUTA)
- Figure 6. Behavior in fault condition (how a fault can be cleared)
- Table 13. Electrical transient requirements (part 1)
- Table 14. Electrical transient requirements (part 2)
- Table 15. Electrical transient requirements (part 3)
- 2.5 Reverse battery protection
- Figure 7. Definition of the delay times measurement
- Figure 8. Definition of the low-side switching times
- Figure 9. Definition of the high-side switching times
- Figure 10. Definition of dynamic cross conduction current during a PWM operation
- Figure 11. Waveforms in full bridge operation (part 1)
- Figure 12. Waveforms in full bridge operation (part 2)
- Figure 13. Definition of delay response time of sense current
- Figure 14. Half-bridge configuration
- Figure 15. Multi-motors configuration
- 3 Package and PCB thermal data
- 3.1 MultiPowerSO-30 thermal data
- 4 Package and packing information
- 5 Order codes
- 6 Revision history
VNH5019A-E Package and packing information
Doc ID 15701 Rev 7 31/34
4.4 MultiPowerSO-30 packing information
The devices can be packed in tube or tape and reel shipments (see Table 19: Device
summary for packaging quantities).
Figure 25. MultiPowerSO-30 tube shipment (no suffix)
Figure 26. MultiPowerSO-30 tape and reel shipment (suffix “TR”)
A
B
C
Dimension mm
Base q.ty 29
Bulk q.ty 435
Tube length (± 0.5) 532
A3.82
B23.6
C (± 0.13) 0.8
Reel dimensions
SO-28 tube shipment (no suffix)
Dimension mm
Base q.ty 1000
Bulk q.ty 1000
A (max) 330
B (min) 1.5
C (± 0.2) 13
D (min) 20.2
G (+ 2 / -0) 32
N (min) 100
T (max) 38.4
To p
cover
tape
Start
No componentsNo components Components
500 mm min
500 mm min
Empty components pockets
User direction of feed
Tape dimensions
According to Electronic Industries Association
(EIA) Standard 481 rev. A, Feb 1986
Description Dimension mm
Tape width W 32
Tape hole spacing P0 (± 0.1) 4
Component spacing P 24
Hole diameter D (± 0.1/-0) 1.5
Hole diameter D1 (min) 2
Hole position F (± 0.1) 14.2
Compartment Depth K (max) 2.2
Hole Spacing P1 (± 0.1) 2
End