Owner's Manual

MOUNTING
The Atrium's bracket allows it to be mounted
either horizontally or vertically and aimed to
deliver the best possible sound in a variety
of situations. Follow the steps below to safely
secure the brackets and speakers.
Installation of Atrium Series Loudspeakers
requires basic skills in using tools such as a
drill
and screwdriver. If you are in doubL that
you possess the necessary skills or tools,
consult your Polk Audio dealer, or a
professional installer.
1) Make sure thc material on which you
plan to mount Lhe speakers (plaster,
drywall,
paneling, stone, etc.) can
support the weight of the speakers
(ALrium65sDl=approx 12LBS- 5.45kg oa).
2) Make sure thc locations you selcct do not
conceal electrical wiring or plumbing.
:{) Prior to installation, hold Lhe speaker in
the chosen location to make sure it safely
clears obstacles such as ceiling, adjacent
walls, corners, beams, lighting fixtures
and door/window frames.
FIGURE \ \
Turn the bracket knobs 10 remove the brocket assembly.
Gire las peril/as de los soportes para quilor la unidad de soparte.
Tournez les boulons du support pour relirer Ie bloc-support.
Drehen Sie die Halterungsknopfe,
um die gesamte
Halterung abzunehmen.
4) Using the keyhole slots in the bracket as a
template, mark the installation location of
the two keyhole slots with a pencil. You
can do this by removing the bracket knobs
on the top and bottom of the speaker and
removing the bracket, or by leaving the
bracket connected to the speaker [figure
111. Orient. the bracket so that. the small
ends of the keyhole slots are [acing "up"
according to the direction of installation.
l~eattach the bracket La the speakers, if
you have removee! it, by reinserting it into
the bracket gap and t.hen tightening the
bracket knobs.
S) If you are certain tha t there is a stud
behind the wall surface, drive #10 screws
(not included) through the wall and into
the stud [figure 12aJ.
6) If there is no stud behind the wall at the
chosen location, install #10 wa II anchors
(not supplied) into the wall by following
the wall-anchor-manufacturer's instruc-
tions. Always use two wall anchors and
two screws per speaker [figure 12bJ.
7) Drive screws into stud or wall anchors,
leaving scre\v heads protruding 1/16"
(1/6mm).
figure 12a
Wall Stud
.-..0
~ .-..0
~
figure 12b·
No Wall Stud
FIGURES 120 & b
Use #10 screw for wall stud,
use #10 woll anchors + screw for no wall stud.
Use Iornillos n· 10 si la pored tiene parales internos, use ane/as
de pored y Iorn;Ilos n· 10 si 10 pared no liene paroles internos.
Utilisez une vis no I0 pour fixer Ie support dans un monlont.
Ulilisez une cheville d'ancroge et une vis
nolO s'il n'y a pas de monlont.
Verwenden Sie eine Schraube Nr. 10 fur Wan de mit
Holzstielverstiirkung bzw. Dubel und Schrauben (Nr. 10) fUr
Wonde ohne Holzslielverstiirkung.
6 Get more information and exclusive accessories, visit www.polkaudio.com