Owner manual LCD TV with Digital Tuner

Chapter 2 Installing the LCD TV

Use a supplied antenna cable to connect the TV signal to the LCD TV’s TV CABLE terminal.

VHF/UHF IN

Connect the AC power cord at the back of the TV and connect the power cord to wall outlet.

Press the POWER button on your remote to turn on your LCD TV.

a. After connecting an aerial to your LCD TV and connecting the mains cable to the

TV and 230VAC mains socket, turn the POWER SWITCH of rear TV on, a red light

will show on the front centre panel of the TV.

b. Press the POWER button, the red light will change to green and the First Time

Installation screen will show:

1. Make sure an aerial is ﬁ tted then press OK button on the remote to start

the Auto Programme Scan (APS).

2. In a short while you will see the TV programmes brieﬂ y as each channel is

received and stored in the memory. When APS is completed BBC1 will show,

press CH+/- buttons to view the other channels stored.

c. To power off press the POWER button, the green light will change to red.

Press the SOURCE button and choose TV or DTV mode then press OK to select.