LCD Flat Panel Operation Manual LCD-1700, LCD-2000
-4-
Important safeguards
11. Power source
 This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of
 power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery 
 power, or other sources, refer to the operating instructions.
12. Power cord protection
 Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against
 them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
13. Outdoor antenna Grounding
If an outside antenna or cable system is connected to the TV, 
 be sure the antenna or cable system is grounded to provide 
 some protection against voltage surges and built-up static 
 charges. Section 810 of the National Electrical Code, 
 ANSI/NFPA NO.70, provides information with respect to proper
 grounding of the mast and supporting structure, grounding of 
 the lead-in wire to an antenna discharge unit, size of 
 grounding conductors, location of antenna discharge 
 unit, connection to grounding electrodes, and requirements
 for the grounding electrode.
14. Lightning
 For added Protection for this TV receiver during a lightning 
 storm, or when it is left unattended and unused for long 
 period of time, unplug it from the wall outlet and disconnect 
 the antenna or cable system. This will prevent damage to 
 the TV due to lighting and power line surges.
15. Power lines
 An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits,
 or where it can fall into such power lines. When installing an outside antenna system, extreme care should be taken to keep 
 from touching such power lines or circuits as contact with them might be fatal.
16. Overloading
 Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
17. Object and liquid entry
 Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that
 could result in fire or electric shock. Never spill liquid of any kind into the TV.
18. Servicing
do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. 
Refer all servicing to qualified service personnel.
19. Damage requiring service 
Unplug this TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:
a. When the power supply cord or plug is damaged or frayed.
b. If liquid has been spilled, or objects have fallen into the TV.
c. If the TV ha been exposed to rain or water.
d. If the TV does not operate normally be following the operating instructions. Adjust only those controls that are coved by the
 operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive
 work by a qualified technician to restore the TV to its normal operation.
e. If the TV has been dropped or damaged in any way.
f. When the TV exhibits a distinct change in performance, this indicates a need for service.
20. Replacement parts
When replacement parts are required, be sure the service technician uses replacement parts specified by us that have the 
same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other 
hazards.
21. Safety check
Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine 
that the TV is in proper operating condition.
22. Heat
This TV product should be situated away from heat sources such as radiation, stoves, or other products (including amplifiers) 
that produce heat.
23. Non-active pixels
The LCD panel is a very high technology product with 921,600 thin film transistors, giving you fine picture details. Occasionally,
 a few non-active pixels may appear on the screen as a fixed point of blue , green or red. Please note that this does not affect the 
 the performance of your product.










