User manual

Operation
Do not set up or operate the product under water.
Make sure that the cables hang loosely and are not
stretched too tightly. Failure to heed this warning may
cause the cables to tear.
Do not fasten the product directly to the installation
surface, do not use, for example, any pushpins. First
install suitable holders and then lay the product on the
holders.
Do not connect the product to the power supply while
it is still in the packaging. Lay the product out entirely
before connecting it to the power supply.
Do not hang any objects from the product and do not
cover the product.
The LEDs are not dimmable.
1. Lay the product out entirely and arrange the cables so that
they lie freely and are not tangled.
2. Select a suitable installation site (i.e. wall, eave, tree or bush)
and install suitable holders for the product (i.e. screw hooks,
nails, etc.).
3. Lay the product on the holders you have just installed or on
the branches of the tree or bush. Use plastic cable ties to
fasten the product if necessary.
4. Connect the plug to the correct connector on the
transformer.
5. Secure the connection by turning the plug‘s screw cap onto
the transformer‘s thread.