User manual
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or
connection of the device.
• Maintenance, modifications and repairs are to be performed
exclusively by an expert or at a qualified shop.
• If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Product overview
12.35 m
PLC-03-006
PLC-03-007
5 m
15 cm
16.85 m
5 m
15 cm
Operation
Do not set up or operate the product under water.
Make sure that the cables hang loosely and are not
stretched too tightly. Failure to heed this warning may
cause the cables to tear.
Do not fasten the product directly to the installation
surface, do not use, for example, any pushpins. First
install suitable holders and then lay the product on the
holders.
Do not connect the product to the power supply while
it is still in the packaging. Lay the product out entirely
before connecting it to the power supply.
Do not hang any objects from the product and do not
cover the product.
The LEDs are not dimmable.
1. Lay the product out entirely and arrange the cables so that
they lie freely and are not tangled.
2. Select a suitable installation site (i.e. wall, eave, tree or bush)
and install suitable holders for the product (i.e. screw hooks,
nails, etc.).
3. Lay the product on the holders you have just installed or on
the branches of the tree or bush. Use plastic cable ties to
fasten the product if necessary.
4. Connect the plug to the correct connector on the
transformer.
5. Secure the connection by turning the plug‘s screw cap onto
the transformer‘s thread.
6. Connect the transformer to a power outlet.
7. Disconnect the transformer from the power outlet for
extended periods of disuse.
The product has no power switch and is always on as long as
it is connected to the power supply.
Maintenance and cleaning
• The product is maintenance-free apart from occasional
cleaning.
• Disconnect the transformer from the power supply before
cleaning and allow the LEDs to cool down suciently.
• To clean, use a clean, dry, lint-free cloth. For stubborn dirt,
slightly dampen the cloth with water.
• Allow the product to dry completely before continued use.
Disposal
Electronic devices are recyclable waste and must not
be disposed of in the household waste. At the end of its
service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute
to the protection of the environment.
Technical data
a) Lightchain
Item No. PLC-03-006 PLC-03-007
Protection type IP44
Operating voltage 24 V/DC*
Power consumption max. 3.84 W
Number of lights 50 80
Luminous colour Warm White
Power cable length 5 m
Total length approx. 12.35 m approx. 16.85 m
Distance between
lights
15 cm
Operating conditions -20 to +60 °C / 20 – 80 % RH
Storage conditions -20 to +60 °C / 20 – 80 % RH
Weight 480 g 525 g
*The rectifier on the supply line of the light chain converts
alternating current into direct current. Therefore, use only the
transformer that is provided.
b) Transformer
Protection type IP44
Input voltage 230 V/AC, 50 Hz
Output voltage 24 V/AC
Output current 166.7 mA
Output power max. 4 W
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. The operating instructions
reflect the current technical specifications at time of print.
© Copyright 2014 by CEI Conrad Electronic International (HK) Limited
PLC-03-006-007_v1_0814_02_m_EN(1)
distributed by Conrad Electronic SE,
Klaus-Conrad-Str. 1, D-92240 Hirschau