User manual

Product overview
4.5 cm 7 cm
11 cm
Operation
The product must not be used in or under water.
Do not use the product when it is still in the packaging.
Do not hang objects on the product or cover the
product.
The LED is not dimmable and cannot be replaced.
Before using the lamp for the first time, leave it to charge in
the sun for approximately 8 hours. The battery will last for
approximately 8 hours after a full charge.
1. Remove the product from the packaging.
2. The lamp provides two dierent colors: warm white, and
RGB. To turn on the lamp, move the on/o switch on the
battery compartment to the ON positions (ON1 = white; ON2
= RGB). The lighting color is changed via the switch on the
battery compartment.
3. The LEDs turn on automatically when the ambient brightness
is low and turn o again during sunlight hours. If the ambient
brightness is sucient, the rechargeable battery will be
recharged via the solar module.
4. Place the lamp in a location with good access to sunlight so
that the solar cell can charge the battery during the day. The
solar cell should not be covered or placed in the shade (e.g.
from trees or buildings).
5. To turn o the lamp, move the on/o switch on the battery
compartment to the OFF position. Switch o the solar
decoration when not using it for a long period of time. When
at this switch position, the rechargeable battery will not be
charged.
Important notes
• The power of the solar panel varies according to the time
of year and depends on the duration and strength of the
sunlight. Long periods without sucient sunlight (especially
in winter) may lead to a shorter battery life (the rechargeable
battery stores less energy during the day than it consumes at
night). This may damage the battery as a result of it becoming
completely discharged. To avoid damaging the battery, turn the
lamp o during extended periods without sucient sunlight.
• Keep the surface clean. Dust and dirt reduce the eciency of
the solar panel, resulting in a lower charging current.
• During poor weather, you can remove the battery and charge it
with a suitable battery charger. Always follow the instructions in
this manual when removing/replacing the battery.
Replacing the battery
• Replace the battery when you notice a significant drop in the
battery life despite sucient charging.
• Ensure that the on/o switch is set to the OFF position before
opening the battery compartment.
• Remove the battery compartment cover by loosening the six
screws with a small Phillips screwdriver.
• Insert a new battery of the correct size and type (see “Technical
Data”) into the battery compartment. Ensure that the battery is
inserted in the correct polarity (“+” = positive; “-” = negative).
• Replace the battery compartment cover and tighten the screws.
Care and cleaning
• Before cleaning the product, turn o the lamp and let it cool
down suciently.
• Use a clean, dry, lint-free cloth to clean the products. To remove
stubborn dirt, moisten the cloth slightly with lukewarm water.
• Do not press too hard on the solar panel, as this may damage
the interior components.
• Let the product dry out completely before using it again.
Disposal
a) Product
Electronic devices are recyclable waste and must not
be placed in household waste. Always dispose of the
product according to the relevant statutory regulations.
Remove any inserted batteries and dispose of them
separately from the product.
b) Rechargeable batteries
As the end user, you are required by law to return all
used rechargeable batteries. They must not be placed in
household waste.
Rechargeable batteries that contain hazardous substances are
labelled with this symbol to indicate that disposal in household
waste is forbidden. The abbreviations for heavy metals in
batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (indicated
on the battery, e.g. below the waste icon on the left).
Used rechargeable batteries can be returned to local collection
points, our stores or battery retailers.
You thus fulfil your statutory obligations and contribute to the
protection of the environment.
Technical data
Protection rating IP44
Power supply
1 x 1.2 V, 500 mAh NiMH rechargeable
battery (AAA)
Power consumption 0.04 W
Battery life approx. 8 hours
Number of lights 2
Lamp colour Warm white & RGB
Operating conditions -20 to +40 °C
Storage conditions -20 to +40 °C
Dimensions (Ø x H)
11 x 4.5 cm (net height)
11 x 11.5 cm (total height)
Weight 150 g (±15 g)
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau 1675016_V4_1018_02_mxs_m_en
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method (e.g. photocopying, microfilming, or the capture in electronic data processing
systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. These operating
instructions reflect the current technical specifications at the time of printing.
© Copyright 2018 by CEI Conrad Electronic International (HK) Limited