User manual

These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method (e.g. photocopying, microlming, or the capture in electronic data processing systems)
requires prior written approval from the editor. Reprinting, also in part, is prohibited. The operating instructions reect the
current technical specications at time of print.
© Copyright 2018 by CEI Conrad Electronic International (HK) Limited *1642714_5_V1_0118_02_LS_m_EN_(2)
• Cold temperatures have a negative impact on the battery life (the light stays on for a shorter
period at night). To prolong the lifespan of the product, store it in a dry, warm room during the
winter (or when you are not going to use it for an extended period). Switch off the product
during this time.
• You can charge the battery with a battery charger before inserting it into the product. Always
follow the instructions in this manual when removing/replacing the rechargeable battery.
Removing/changing the battery
Ensure that no liquids get into the interior of the product when changing the battery.
Replace the battery when you notice a signicant drop in the battery life, or when the light only
turns on for a short period despite sufcient sunlight during daylight hours.
• Hold the product upside down with the battery compartment (5) facing upwards.
• Ensure that the on/off switch (4) is set to the OFF position before opening the battery
compartment.
• Loosen the screws on the bottom of the battery compartment with a suitable Phillips
screwdriver.
• Remove the battery compartment cover and seal.
• Remove the battery from the battery compartment.
• Replace the used/defective battery with a new battery of the same type and capacity (see
"Technical data"). Ensure that the battery is inserted in the correct polarity (observe plus/+
and minus/- symbols).
• Reassemble the lamp in reverse order. Ensure that the seal is attached properly.
Care and cleaning
• Do not use abrasive detergents, rubbing alcohol or other chemical solutions, as these may
damage the casing or stop the product from functioning properly.
• Never point water jets (e.g. from a high-pressure cleaner) at the product, as this may damage
the seal.
• Use a clean, soft and dry cloth to clean the product. To remove stubborn dirt, moisten the
cloth slightly with lukewarm water.
• Do not press too hard on the lighting unit (1), as this may damage the product.
• Remove dust from the lighting unit on a regular basis, otherwise the charging current may
drop.
Disposal
a) Product
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
Remove the rechargeable battery and dispose of it separately from the product.
b) Rechargeable batteries
You are required by law to return all used batteries. They must not be placed in
household waste.
Rechargeable batteries that contain hazardous substances are labelled with this
symbol to indicate that disposal in household waste is forbidden. The abbreviations
for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (indicated
on the battery, e.g. below the waste icon on the left).
Used rechargeable batteries can be returned to local collection points, our stores or battery
retailers.
You thus full your statutory obligations and contribute to the protection of the environment.
Technical data
Power supply ................................ 1 x 1.2 V, 600 mAh NiMH rechargeable battery (AAA)
(item no. 1642714)
1 x 1.2 V, 300 mAh NiMH rechargeable battery (AAA)
(item no. 1642715)
Power consumption ...................... max. 0.16 W (item no. 1642714)
max. 0.08 W (item no. 1642715)
Light-on time ................................. approx. 6 - 8 hours
Protection type .............................. IP44
Light bulb ...................................... 1 x LED (not replaceable)
Light colour ................................... neutral-white
LED life ......................................... 10,000 hours
Operating/storage conditions ........ -20 to +40 °C
Dimensions (Ø x H) ...................... 141 x 151 mm (item 1642714)
100 x 100 mm (item 1642715)
Weight .......................................... 180 g (item 1642714)
100 g (item 1642715)
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau