Handbook
J. Hose Length
To service the feed hose, refer to “Hose Cutting” in Section II (380 refer to
page 3; 360 refer to page 7.)
IX. PART REMOVAL AND REPLACEMENT
A. Single-side Wheel
DISASSEMBLY:
1. Remove the head float.
2. Remove the tops (screw is on the double-wheel side).
3. Remove the hub cap.
4. Remove the e-clip.
5. Remove the wheel.
6. Remove the tire from the wheel.
REASSEMBLY:
1. Install the tire on the new wheel.
2. Support the transfer pulley shaft and install the new wheel by pushing it
down onto the shaft until the e-clip groove is flush with the wheel.
3. Replace the e-clip.
4. Replace the hub cap.
5. Replace the tops:
• Install the top for the double-
wheel side; make sure the
tabs are inside the base.
• Install the top for the single-
wheel side; make sure the
tabs are inside the base.
Push down on the top until it
snaps into place.
• Install the screw from the double-wheel side.
6. Replace the head float to the recommended setting.
B. Drive Train Removal and Replacement
The following DRIVE TRAIN REPAIR AND REPLACEMENT steps must be
followed for Sections C through H below. Note: Whenever possible, check
the bearings and replace them if they do not spin freely.
DISASSEMBLY:
1. Remove the head float.
2. Remove the tops (screw is on
the double-wheel side).
3. Remove the feed pipe/timer
blank assembly (3 screws).
4. Loosen the four frame screws.
5. Lift up at the rear of the frame
and pull straight up.
3534
Floats Are Evenly Distributed
(1-1/2 to 3 Feet Apart)
Universal Wall
Fitting
Properly Sized Feed Hose
2-3 Feet Apart
White Hoses Are Cut to Equal Lengths
Clear Hose is Equal to
Greatest Depth of Pool
Entire Feed Hose Reaches Within 6" of Farthest Point of Pool
Feed hose is cut correctly if:
A. Clear hose is equal to greatest depth of pool.
B. Hard white hoses are equal in length.
C. Entire feed hose reaches within 6” of farthest point of pool.
D. Floats on white hoses are spaced evenly, between 1-1/2 to 3 feet apart.
Universal Wall
Fitting
Entire Feed Hose Reaches Within 6" of Farthest Point of Pool*
Cut excess hose from
first section of hose
7'
Float
Float
Float
4'
Measure with pool
pump on and pressure
tester underwater
Pressure Tester
Properly Sized Feed Hose for 360
Properly Sized Feed
Hose for 380