Owner's manual

TURF MODE (IF EQUIPPED)

When operating in TURF mode, the inside rear wheel will rotate independently

from the outside wheel during turns. Operate in TURF mode only as needed to

protect smooth, level surfaces from tire damage. DO NOT operate in TURF

mode when climbing or descending hills, when sidehilling, or when operating on

uneven, loose, or slippery terrain such as sand, gravel, ice, snow, obstacles, and

water crossings. Always operate in ADC 4X4 or 4X4 on these types of terrain.

WARNING

Operating in TURF mode when on sloped, uneven, or loose terrain could

cause loss of control and result in serious injury or death. One rear wheel may

slip and lose traction or may lift up and grab when it touches the ground again.

4WDC AWD MODE (IF EQUIPPED)

Move the momentary switch to the right,

past the AWD setting, to engage 4WDC

(if equipped). When the switch is on

4WDC, the ADC system allows engine

braking to all four wheels when the

vehicle descends a hill or incline.

Always move the 4X4 switch to 4WDC

before ascending or descending a hill.

FOUR-WHEEL DESCENT CONTROL (4WDC) SYSTEM

The 4WDC system allows engine braking to all four wheels when the vehicle

descends a hill or incline. Always move the 4X4 switch to 4WDC before

ascending or descending a hill.

ENGAGING FOUR-WHEEL DESCENT CONTROL

The 4WDC system will automatically engage when all four of the following

conditions occur:

• The 4X4 switch must be in the 4WDC position

• The throttle must be closed (throttle lever released)

• The transmission must be in gear (high, low or reverse)

DISENGAGING FOUR-WHEEL DESCENT CONTROL

The 4WDC system will automatically disengage if at least one of the following

conditions occur:

• The 4X4 switch is moved out of the 4WDC position

• The throttle is open (throttle is applied)

• The transmission is shifted to neutral or park

• The vehicle is on flat ground, or not actively descending a hill

FEATURES AND CONTROLS